BLACK WIRE
- SYSTEM GROUND
Connect the alarm's black wire to a good chassis ground in the
drivers kick panel area. Do not connect to factory wiring. Connect
this wire first. Do not confuse this wire with the small thin black
antenna wire.
YELLOW WIRE -
SYSTEM SWITCH POWER
Connect the yellow wire to true
ignition. This is 12 volts power when the key is in the
"on" and "crank" position.
VIOLET WIRE -
DOMELIGHT CONTROL (-) 500mA)
This wire is the negative dome light
output. It turns on the vehicle's interior lights for 20 second when
the keyless is unlocked (relay required, see diagram).
Note: A
relay must be used to control the dome light. Do not connect the
VIOLET wire directly to the dome light wire or the door pinswitch
wire.
GRAY WIRE -
SECOND CHANNEL OUTPUT
This wire is the alarm's second
channel negative (-) 500mA output. It only operates with ignition
off. This momentary output switches to ground when the #2 button of
the remote control is pressed for 3 seconds. It may be used with a
relay (not provided) for remote trunk release, or may be used to
trigger other optional equipment (i.e. remote car starter, window
roll up, etc.). See diagram.
Illustration shown is for 12 volt positive
trunk switch. For negative switch, 87 will go to ground and 85 will
be 12 volts. |
