|
Installation
Instructions
RED WIRE - 12
VOLT CONSTANT SYSTEM POWER
The alarm's red wire with the 15 amp fuse in connected to a
constant, positive (+) 12 volt supply. Do not eliminate fuse holder.
Doing so will void warranty.
WHITE WIRE -
PARKING LIGHTS
The white wire is a positive output from the on-board light flash
relay. The white wire may be connected to the vehicle's parking
light wire at the headlight switch. Do not connect to headlights as
amperage draw would be excessive.
BROWN WIRE -
SIREN OUTPUT (+)
Connect the brown wire to the brown wire of the siren. The siren's
black wire should be connected to a clean chassis ground.
BLACK WIRE -
SYSTEM GROUND
Connect the alarm's black wire to a good chassis ground in the
drivers kick panel area. Do not connect to factory wiring. Connect
this wire first.
YELLOW WIRE -
SYSTEM SWITCH POWER
Connect the yellow wire to true ignition. This is 12 volts power
when the key is in the "on" and "crank"
position.
VIOLET WIRE -
POSITIVE DOOR SWITCH INPUT
The violet wire is positive (+) for door pin trigger.
GREEN WIRE -
NEGATIVE DOOR SWITCH INPUT
The green wire is negative (-) for doorpin trigger.
BLUE WIRE -
GROUND TRIGGER INPUT
The blue wire is for negative (-) trunk/hood trigger only. NOTE: Do
not hook up extra sensors to this wire. Extra sensors can be hooked
up to the shock sensor blue wire (See sensor instructions). |
